Rail cutting parts are generally used to produce and process ordinary stainless steel plates, stainless steel plates, metal materials and non-metal materials. Since the cutting part rotates at a high speed during the entire application process, the raw material must be cut with a certain strength. Therefore, it is necessary to ensure the quality gap of the rail cutting part to prevent some dangers in the middle and late stages of the entire application process. What are the hazards of unqualified rail cutting parts?
1. Shake hands
When the rail cutting blade is running at a high speed, the vibration is severe when holding the handle, and the cutting efficiency is reduced, resulting in waste. The reason is caused by unbalanced cut pieces.
2. Bridge Leng, that is to say film
When the rail cutting part is running at high speed, the motion track cannot be parallel. The direct adverse effect is the inclined residue of the raw material after cutting, which cannot exceed the production and processing regulations.
Three, cracking and broken
During high-speed operation, due to the poor quality of the steel wire mesh, too little or expired flux, and too low temperature in the industrial kiln, the rail cutting parts will crack. When it is severe, it will cause crushing and death.
